Long EZ Vertical Hold Auto-pilot Bell horn 1.25

( For Experimental Aircraft ) Bell Horn is milled from Billet 6061-T6 Aluminum Bar stock. Base is made from same material with a 1.25 Inside Diameter to fit perfectly over the 1.25 OD Long EZ GU canard elevator torque Tube. It secures with a single rivet and two 1/2 wide stainless steel worm clamps. Bell Horn has multiple adjustments so you can achieve the correct geometry between servo arm and elevator torque tube. Arm is .1875 thick welded to a half moon .060 thick aluminum base.  Overall height from the top of the radius to the top of the arm is 2.45 inches. Total height is 3.125. The 1.25 inch ID radius base is approximately 2.0 inches wide in length.