Home > AIRCRAFT PARTS

Long EZ Vertical Hold Auto-pilot Bell horn 1.375

Part Number Long-EZ BH 1.375

2 Review(s)

Long EZ Vertical Hold Auto-pilot Bell horn 1.375

Long EZ Vertical Hold Bell Horn 1-3/8

Write a Review

Price

Your Price:

$69.00

Availability:

Quantity

Description

( For Experimental Aircraft ) Bell Horn is milled from Billet 6061-T6 Aluminum Bar stock. Base is made from same material with a 1.375 Inside Diameter to fit perfectly over the 1.375 OD Long EZ RONZ canard elevator torque Tube. It secures with a single rivet and two 1/2 wide stainless steel worm clamps. Bell Horn has multiple adjustments so you can achieve the correct geometry between servo arm and elevator torque tube. Arm is .1875 thick welded to a half moon .060 thick aluminum base. Overall height from the top of the radius to the top of the arm is 2.45 inches. Total height is 3.125. The 1.375 inch ID radius base is approximately 2.0 inches in length.

Customer Reviews

	Retired Pilot
	Nice little device to help easing the autopilot installation on my Long EZ. Looks well built, although not quite like the photo (it has 5 fewer adjustment holes than the photo shows. It has just the inline holes down the center, and not the offset ones) but that should not be a problem, and probably stronger than the one in the photo! Other than that, the weld looks great and it seems more than substantial enough for the Dynon D180 servo to operate the canard mounted elevators. One less thing I have to design and engineer! (Sorry we redesigned it for the strength reason. Phil)
	Did you find this helpful? 1 of 1 Found Helpful Reviewed by: Harley Dixon from Henrietta, New York. - 9/10/2019 5/5

	nicely built and strong
	The arm fits perfectly on the elevator torque tube. This saved me time building one and really better than what I would have made.
	Did you find this helpful? Reviewed by: Ron Larock from Massachusetts. - 6/25/2022 5/5